Search

What Are Rubber Bands Used for in Orthodontics?

By: Doctor Solanch Morales

Orthodontic Bands - Helping to Align Your Bite

Rubber bands are essential for correcting the alignment of your bite. While braces move individual teeth, elastics provide extra force to adjust the position of the upper and lower jaws. They help fix issues like overbites, underbites, crossbites, and open bites by guiding the teeth into their correct positions.

Rubber Band Sizes and Lengths

Orthodontic rubber bands come in various sizes, lengths, and thicknesses, all of which impact the amount of force applied to the teeth. The main differences include:

  • Size (Diameter): Ranges from small to large, usually measured in fractions of an inch. Smaller bands exert more force, while larger ones provide gentler pressure.
  • Thickness (Force Level): Thicker bands provide more resistance, which increases the force applied to the teeth. They are usually classified as light, medium, or heavy.
  • Length: The stretchiness of the band determines how much force is maintained over time. Shorter bands provide a stronger initial force but may lose elasticity faster.

Your orthodontist will determine the best size and strength based on your specific needs.

Closeup of a woman with braces wearing power chains and orthodontic elastics to correct her bite.

How Many Daily Hours Should You Wear Rubber Bands?

For the best results, rubber bands should be worn at least 20–22 hours a day. This means you should wear them all the time except when eating, brushing, or flossing. Consistency is key—removing them too often can slow down your progress and extend your treatment time.

How Frequently Do You Change Rubber Bands?

Rubber bands lose their elasticity over time, reducing their effectiveness. To maintain consistent pressure, you should change your elastics 3–4 times a day or as directed by your orthodontist. A good habit is to replace them after meals and before bed.

Different Types and Configurations of Rubber Band Use

Orthodontic elastics are placed in different patterns depending on the correction needed. Some of the most common configurations include:

1. Class II Elastics

Used to correct an overjet (when the upper teeth are too far ahead of the lower teeth). These bands connect the upper canine to the lower molar, helping to move the lower jaw forward and the upper teeth back.

2. Class III Elastics

Designed for fixing an underbite (when the lower teeth are in front of the upper teeth). These bands attach from the lower canine to the upper molar, helping to pull the lower jaw backward and the upper jaw forward.

3. Triangle Elastics

Animated image of Triangle Elastics placement for orthodontic rubber bands.

Used for closing open bites by connecting three teeth in a triangular formation—usually an upper canine and two lower teeth. This setup encourages the teeth to come together properly.

Final Thoughts About Orthodontic Rubber Bands

Wearing rubber bands as instructed is crucial to the success of your orthodontic treatment. When you put force on a tooth it starts to move a little bit.  When you take the force off the tooth it will begin moving back. So, if you wear your rubber bands for just an hour and then leave them off for 3 hours, your teeth probably didn’t make any progress!

In order to get your teeth to move permanently, you must apply constant force over a long time. The longer the better! That is why wearing your rubber bands day and night (even to bed) is very important

Remember—consistency and patience will bring you closer to that perfect smile!

Author:

Dr. Solanch Morales – DMD, MBA, ABO

Board Certified Orthodontist

Arlington

Aubrey

Dallas

Lewisville

McKinney

The Colony

Request appointment at: